Measure Corexy Belt Tension
Hi,
Is there a video or document on how to get this tension correct.... I must be a bit "slow"... lower belt was loose and slowly increased it and was getting close to upper.... but then when I tighten the lower belt a bit more, the upper belt peak shot up....Don't understand obviously and need a guide.
Was also wondering how to get the first belt's right? Is it supposed to be a certain frequency? And then get the second belt to match?...
Lots of corruption/dirty
After not touching my Vcore 3.1 500 for a while, it now looks like this. Does this look like an SD card issue or something else? There is a very small chance the Pi got knocked by something, but it's impossible to know.
Exclude Object
Hello. After loading up an object in my slicer and printing, I am getting this message constantly in the console section of RatOS. Is this a common issue?
Problems with printer.cfg
So i followed the configuration of ratos, unfortunately i have issues with the motors. Could someone help ?
Solved: Setting up ADXL
Hey all. Is there anything special I need to enable to get the adxl running?
I wired it into my Spider 2.3 (see pic), but when I try to”generate shaper graphs” script in mainsail, Console reports “Invalid adxl345 id (got from instead of e5)”
I know SPI needs to be enabled to use this header on the board, and the RatOS site indicates it’s usually enabled but I don’t know if SPI is actually enabled and may be involved in the error. Thanks for any help. ✌️...
BTT Pad 7 - Unable to install any feature, change time zone, etc,
Hello everyone,
I am using a Pad 7 with my vcore 500. I used the 2023-06-09-RatOS-2.0.2-armbian-CB1.img.xz img to flash the Cb1.
All my issues started first when I wanted to change the time of the Pad 7 to my timezone. However, the system won't allow me to send the sudo raspi-config command (see picture). Then, I have tried to install some features (octoeverywhere) from kiauh and it won't allow me to do so (see pictures)....
