Norparn
RRCRat Rig Community [Unofficial]
•Created by Norparn on 3/6/2024 in #fix-my-mesh
Kamp not working
I have followed the instructions on GitHub regarding Kamp but i get an klipper error that says ''Section 'include ./kamp/adaptive_meshing.cfg' is not a valid config section'' . I have double checked everything and i do not know what the problem is. My klipper version is ''Version: v0.12.0-114-ga77d0790 ''. Have anyone gotten kamp to work on a ratrig or now what i might be doing wrong. https://github.com/kyleisah/Klipper-Adaptive-Meshing-Purging
3 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 11/16/2023 in #ratos-support
Timelapse not working
Hi I can't get timelapse to work, have put [include timelapse.cfg] in printer.cfg. In start g code in the slicer I have the command TIMELAPSE_TAKE_FRAME. But when it starts printing, it says "Timelapse: disabled, take frame ignored" in the console. I don't know how to make it enabled .
4 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/16/2023 in #fix-my-printer
LDO ADXL345 install
Hi, I bought an ldo input shaper https://3do.eu/boards/734-ldo-input-shaper-kit.html I've tried a lot of different things and can't get it to work. Does anyone know how to set this up in klipper?
3 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/13/2023 in #fix-my-printer
Rapido hotend not going below 179 degrees
Hi, have built a ratrig V core 3.1 with a rapido uhf and an octopus 1.1. As soon as klipper starts the hotend temperature goes up to 179 degrees, although "State" says the heater is off and "Target" is set to 0. and when I set the temperature to 200 degrees, it bounces around between 200- 230 degrees, and "state" jumps between 0 and 100% nothing else. Does anyone know what the error could be.
6 replies