Norparn
RRCRat Rig Community [Unofficial]
•Created by Norparn on 3/6/2024 in #fix-my-mesh
Kamp not working
oooo, did not know that that was a thing. thanks i will use that 🙂
3 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 11/16/2023 in #ratos-support
Timelapse not working
yes, thank you so much 🙂
4 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/16/2023 in #fix-my-printer
LDO ADXL345 install
I i am using a octopus 1.1. bord
3 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/13/2023 in #fix-my-printer
Rapido hotend not going below 179 degrees
Okay this is very strange, I tried a lot of different things and nothing worked, had the same problem. Then when I woke up today, I thought of measuring the voltage with a volt meter on the contacts where the heating element is connected to see if it is constantly putting out power. When I nudged the contacts on the Octupe's card, it shut down and restarted and now everything works as it should. 🙂
6 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/13/2023 in #fix-my-printer
Rapido hotend not going below 179 degrees
6 replies
RRCRat Rig Community [Unofficial]
•Created by Norparn on 9/13/2023 in #fix-my-printer
Rapido hotend not going below 179 degrees
is this what you mean, sorry if it wasn't clear, but it's scorching hot if you touch it so it's not measuring the wrong temperature it just seems to be getting power all the time
6 replies