First start up, raspberry not showing RatOS wifi
So i finally fully assembled my ratrig vcore 3.1 500. I installed [2023-06-09-RatOS-2.0.2-armbian-CB1.img.xz] using balena, it's been 20 minutes already and it's not showing no wifi. Should the printer be on as well or only the raspberry pi ? It is confusing. Thanks for the help
5 Replies
I assume you have a Manta board and it is on, the printer does not need to be on yet. Did you type in http://ratos.local/configure ? and if you are using 5V USB to power the board instead of PSU, do you have the jumper on?
I fixed it, thank you. I have an octopus v1.1
I have the same problem, the wifi hotspot is not showing, I keep checking both on my phone and laptop, I see no RatOS wifi available..
Make sure you flash the right image. CB1 is for BTT CB1's (and it's experimental - not stable). rpi32 is for raspberry pi products. If that doesn't solve your issue please start your own post.
I think it was SD card related, its all working now