James
RRCRat Rig Community [Unofficial]
•Created by James on 10/13/2024 in #ratos-support
Rat Os crashes when trying to print large file (440mb)
I'm tring to print a large print, i';m not sure if this is a limitation of my hardware (manta m8p) or ratos the file is roughly 2kgs of filament, 400mm tall (its a bust) it takes an age to slice and upload, but when i go to print nothing happens
23 replies
RRCRat Rig Community [Unofficial]
•Created by James on 8/18/2024 in #fix-my-print
anyone get any ideas
11 replies
RRCRat Rig Community [Unofficial]
•Created by James on 8/8/2024 in #fix-my-print
MCU 'toolboard_t0' shutdown: ADC out of range
24 replies
RRCRat Rig Community [Unofficial]
•Created by James on 5/10/2024 in #ratos-support
end stop on ebb 36
I have a manta m8p with a ebb36 tool head finishing the setting up of the printer, the xtop connected to the ebb36 is always showing as triggered. if i connect it the board (using different wires) it works cant seem to fiigure out what is going on
10 replies
RRCRat Rig Community [Unofficial]
•Created by James on 11/12/2023 in #ratos-support
cartesian printer
I want to use rat os on my cartesian printer it's a duel z axis with a manta m8p mother boarded and cb1. I've tried compiling my own clipper but couldnt get it to work properly. I have rat os on my vcore pro and love it. What do I need to do to get this to work
18 replies
RRCRat Rig Community [Unofficial]
•Created by James on 7/27/2023 in #fix-my-printer
z-offset issue
when i go to set my z off set the printed performs a bed mesh test, it asks me to save the config or cancel, if i save it restarts and i have to start again in this endless cycle, if i cancel it just goes back to the menu
10 replies