Help
Lost with this one. I noticed that the diagram said check the wiring. So I have two micro switches and they are opposite way round but the wiring is the same colour. If I fit the two cables to the board the colours in one connector is different to the other and doesn't match the diagram. Not wanting to blew anything up which is right. One picture has been turned upside down so its easier to see.
ADXL345 calculation not returning any info.
When I use SHAPER_CALIBRATE AXIS=X, doesn't return the calculation for the input shaping, it stays like this. Does anyone know why?
The ADXL345 is connected to Octopus
Printer specs: v-minion, Pi 3 Model A+, BTT octopus 1.1.
...
cant get my 4028 to work. I have even bought a new one and still it does nothing.
I wired the blue to ground and the red and black to the upper fan header. set the correct voltage.
Included my printer.cfg and picture of my wiring....
Included my printer.cfg and picture of my wiring....
octopus pro H723 firmware? no conection!
hello, what firmware do you need for octopus pro H723 board? I do not find it!
Manta M8P DFU Mode
Configurator says to hold boot and press reset. That didn't work for me, actually I had to hold Boot, then power on and release boot.
Different Stepper Motor Wiring Configuration
Okay so i just setup RatOS, everithing works well, nothing burned down powering the board up. I setup printer.cfg and all temp sensors are working. I'm using a BTT Manta M8P and i wired all the stepper motors differently not acording to the RatOS wiring diagram, so i would have shorter cables and cleaner wiring for my exact setup. Looking back, it was a mistake, and i just created a problem, but the wires are already cut to size so there is no going back...
How and Where do I change the pinout of the stepper drivers/motors so it works like it was supposted to?......
Disabling hyperlapse doesnt work?
Hey guys, as I am still hunting some usb communication issues, I wanted to turnoff hyperlapse in order to reduce the load produced by my webcam.
I ticked the checkbox to "disabled", but still hyperlapse seems to be called when starting a print. Am I doing something wrong?
Regards!...
mcu shutdown - lost communication
I’ve been battling this random problem and assumed the high cpu usuals of ffmpeg via webcamd was the cause.
Reading that RatOS2 with crowsnest can use the GPU of the RasPi and stream videos without cost, so I took the jump to RatOS2
All looked okay except CPU usage by crowsnest was higher than my earlier problem.
Sure enough 2 days into a four day print I get the crash.
I installed a new USB cable, claimed to be high quality between boards. ...
