SimonSolar2C
SimonSolar2C
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 8/13/2024 in #ratos-support
Octopus firmware version mismatch
No description
6 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 3/13/2024 in #ratos-support
Problem with long RasPi camera cable
Ive been having trrouble with my camera - I want to use the camera port because as I understand it, it can use hardware to avoid too much CPU load. The trouble is, to have the camera at the front corner where I want it, it would seem a long cable is my problem - with same settings and short cable I can get the video feed, however with the longer cable needed for the corner location, I cant get an image using same settings. After days of frustration, changing settings etc., some research identitifd that long acbles have too much line loss. Funny thing is that is was working fine for months, then stopped. Maybe the FFC was damaged where is goes through the cover, so I replaced the cable. Does anyone know a solution/workaround?
2 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 2/9/2024 in #ratos-support
Bridging problem with rapido UHF and 0.6mozzle
No description
3 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 11/29/2023 in #ratos-support
mcu shutdown - lost communication
No description
5 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 9/17/2023 in #ratos-support
mcu shutdown Timer too close - Octopus, Pi4, Vcore3, 500
No description
4 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 7/21/2023 in #ratos-support
Transition to shutdown state: MCU 'mcu' shutdown: Timer too close
No description
10 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 3/5/2023 in #fix-my-printer
XY axis scale wrong
No description
3 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 2/22/2023 in #fix-my-printer
Tightening belts causes y-rail noise Vcore3
No description
7 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 1/27/2023 in #fix-my-resonance
Input Shaper results are inconsistent
No description
3 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 1/22/2023 in #fix-my-print
PLA bubbles up on bed.
No description
4 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 12/19/2022 in #fix-my-resonance
Horrible resonance at specific speed
No description
6 replies
RRCRat Rig Community [Unofficial]
Created by SimonSolar2C on 12/5/2022 in #ratos-support
update changes break height map
No description
9 replies