fluffy
RRCRat Rig Community [Unofficial]
•Created by fluffy on 12/27/2023 in #fix-my-mesh
V-Core 3.1 500mm³ range 2.48
9 replies
RRCRat Rig Community [Unofficial]
•Created by fluffy on 11/30/2023 in #ratos-support
Different Stepper Motor Wiring Configuration
120 replies
RRCRat Rig Community [Unofficial]
•Created by fluffy on 5/31/2023 in #fix-my-printer
Leadscrews ratrig 3.1 kit 500³
I recently got my ratrig kit, it arrived with a scarred bed on the underside (luckly) and with bent leadscrews straight from ratrig, one of them is bent in all different directions but just a little so its fine, but the rest of them is extremly bent and i would say unusable....
they were packed tightly in the 3030 extrusions i carefully slid them out and unpacked, then checked for the straightnes using the rolling on a flat surface technique.
How can ratrig send such bent leadscrews?! Should i contact support right away? Is it even worth it? They might send a replacement but badly packaged and it might get bent again during shipping. What should i do?
6 replies
RRCRat Rig Community [Unofficial]
•Created by fluffy on 5/24/2023 in #fix-my-printer
VCORE3.1 500MM BED ISSUE
2 replies