V-Core 3.1 500mm³ range 2.48
Hello are there any way to improve this mesh even more? there is a big bump in the back where it's supported by the bed arm and it falls down to the sides so my guess is its probably not frame nor rails related.
any tips on how i can improve this?
2 Replies
correct-apricot•13mo ago
.248 is good, how does the first layer look w/ adaptive meshing?
otherwise - your x gantry could be under compression in the back. if you remove the plates holding the arms in front, see if the arms want to push 'out' as you move the gantry from y=0 to y=500. if yes, your gantry is under compression and that's likely causing the hump!
the mesh is no magnet or pei applied
i was able find a post of you talking about the issue and tried loosening the gantry on the xy joiners and tightening it in a different place and i was able to get it down to 0.209
still not sure if that is good enough
when i apply the magnet the whole mesh will most likely get much worse
probably going to replace the y rails while im at it cause you can see i chewed them up while trying to get the gantry to slide smooth with previous xy joiners
thanks for the tip
and is it frame squareness, bracket or extrusion straightness related?