VCORE3.1 500MM BED ISSUE
Hello, my vcore 500mm³ kit just arrived today, sadly i discovered an ugly scar on the bottom side of the bed and many less visible imperfections, is that a problem? It didn't happen during shipping since the peel was on top and untouched, there was just some dirty sludge under the peal on top of the damage... The top side looks good, haven't peeled it yet so im not 100%.
The bottom is quite ugly and probably passed qc.......................
So should i contact support, or just continue the build like nothing happened?
1 Reply
Depends if you are welling to wait then reach out to RR support otherwise, you can check the bed flatness with a ruler or one of the extrusions to see if the bed is bent