Disabling hyperlapse doesnt work?
Hey guys, as I am still hunting some usb communication issues, I wanted to turnoff hyperlapse in order to reduce the load produced by my webcam.
I ticked the checkbox to "disabled", but still hyperlapse seems to be called when starting a print. Am I doing something wrong?
Regards!
15 Replies
Forgive me i don't remember the details of the timelapse plugin but i believe it's partly a slicer thing too
like-goldOP•16mo ago
I dont call it in my slicer at all.....
like-goldOP•16mo ago
this my custom start code
there's a layer change macro and some other stuff.
Don't remember if that's based off of Z height though.. I just don't remember, check the docs,.
like-goldOP•16mo ago
there is no layer change macro.. I only call the adaptive mesh
anyone....?
Try disabling “save frames” as well
like-goldOP•16mo ago
Nope… no success
Comment out the timeline section in printer.cfg / moonraker.conf then i guess
Weird, but not RatOS related, i'd ask over in the mainsail discord wtf is going on.
like-goldOP•16mo ago
I commented out the timelapse sections in printer.cfg and moonraker.conf, but then after I rebooted I got this:
like-goldOP•16mo ago
like-goldOP•16mo ago
I'd start looking for those commands in your config
This is something you've somehow added yourself (something you added is calling those).
Timelapse isn't a native part of ratos, the repo is just preinstalled.
You may need to restart klipper through the services menu in mainsail. Not sure.
actually rebooting would do it too. (all i see in your pic is a firmware_restart)
like-goldOP•16mo ago
you were right. a propper reboot helped (after I out commented)