BTT mini12864 uc1701 V1
Hi, Sorry for my bad english.
I have no screen on my raspberry. So to see where my print is, i had install a BTT mini12864 screen.
I have found on internet all config to put in printer.cfg.
As we can see on the picture, i have artifact and some times during the print, the screen get noreadable
Is someone have any idea why i have that ?...
Option spi_bus and Monraker
After Hard reset of RatOS i ahav 2 problem and now i can't find the problem.
I didn't change anything in the config file....
4 pin Fan cant be controlled
Im trying to use the FAN5 port 4 wire fan on my octopus max EZ ... created a fan_generic in my overrides but I cant control the fan ... only if I disconnect the blue cable the fan runs at 100% ... in my printer.cfg all fans are still with # ... what is my mistake here again
Crowsnest collapses during installation
Hello people,
I've been fighting with crowsnest for several days, and I always encounter the same problem.
At a certain point, about 10-15 minutes after the start of the installation, the system collapses and the connection with the Raspberrypi is lost.
At that moment the fan for cooling the parts turns on.
On the Raspberrypi both the red and green LEDs remain lit. ...
Upgrade Octopus V1.1 to Octopus Pro H723
Hi
Is the Octopus Pro H723 supposed to work just as easy as Octopus V1.1 on the Ratrig 400 when following the setup through RatOS and configurator there ?
I got a few issues on the Pro that i did not get on the V1.1...
Problems after update on X Motor
I just updated to the lastest version when I try to home X keeps jerking then I get this error. "Klipper reports: SHUTDOWN TMC 'stepper_x' reports error: DRV_STATUS: 00130060 s2vsb=1(ShortToSupply_B!) ola=1(OpenLoad_A!) cs_actual=19"
