JuiceWay
RRCRat Rig Community [Unofficial]
•Created by JuiceWay on 1/13/2024 in #ratos-support
pressure advance reverting back to original settings
I’m trying to lower pressure advance a little. After I save config - the change shows up on the dashboard. But once I start print it reverts back to original number, .05.
8 replies
RRCRat Rig Community [Unofficial]
•Created by JuiceWay on 1/11/2024 in #ratos-support
trying to understand configuring RatOs
Is it typical to have to go through and change all the pin names? Like it knows I’m using an octopus EZ - but all the pin names are still just the generic “fan_toolhead_cooling_pin” type names.
Not sure if I’m doing extra work or what. Maybe it’s just because im using the “ez” board?
37 replies