shadyguido
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 3/25/2024 in #fix-my-print
trying to print the fan duct in ASA
14 replies
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 3/21/2024 in #fix-my-print
VERY first blob of skirt won't stick
11 replies
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 1/12/2024 in #ratos-support
Settings Explanations
Is there good resource out there for understanding each of the speed/accel settings in slicer and those displayed in Mainsail?
For example?
When folks talk about getting 1beeelion mms2 acceleration, which specific setting are they talking about?
What's the difference between "velocity" in ratos and the many speeds in prusa slicer?
What does max accel to decel actually mean in mainsail? I don't see it anywhere in the slicer.
These are all dummy questions I know... so is there a good resource out there I can read or watch?
1 replies
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 1/12/2024 in #fix-my-print
GIANT first layer test on my 400mm 3.1
Looks quite high in some spots and quite low in others... Just right in some. What do you think?
1 replies
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 1/12/2024 in #fix-my-resonance
How do I look?
24 replies
RRCRat Rig Community [Unofficial]
•Created by shadyguido on 12/27/2023 in #ratos-support
Can't get Pi to detect Octopus 1.1 - Stuck in first Configuration
I'm just starting my build. I'm in the RatOS Configuration but I don't get the option to flash directly from the Pi. The only option I get is to flash from SD card. I tried to flash from SD card. When I reboot the Octopus, the blue light turns on (recognizing the SD card) but the status light just flashes. When I pull the sd card, the .bin file has not been renamed to .cur and ratos configurator won't detect the octopus.
I'm stumped! FAQ isn't helpful. Any thoughts?
3 replies