Bameron
RRCRat Rig Community [Unofficial]
•Created by Bameron on 4/26/2024 in #fix-my-print
Ringing/Artifacts Only in One Direction?
22 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 4/7/2023 in #fix-my-printer
Belt issues
The belts on my 500mm vcore 3 are moving up and down, and griding against the idlers, causing squeaking noises. I'm not sure how to fix this, and ive rebuilt the gantry with new idlers many times.
There seems to be a bit of artifacting caused by this, so I would appreciate it if someone could help me out.
2 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 2/23/2023 in #fix-my-printer
Belts rubbing against idler
The belts on my machine are riding on the bottom of the xy joiner idlers and the idlers near the front of the machine. When i push the x axis manaully, the motion isn't smooth, and instead is a bit jerky. Could this be an issue caused by frame misalignment? I'm also having weird artifacting so could that be a side effect?
9 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 2/13/2023 in #ratos-support
How do I add a fan? Octopus pro
I'm not sure how to add a fan aside from the three preconfigurated ones. I put in
[fan]
pin: PD14
max_power: 1.0
but that just turns the part cooling fan on
30 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 1/28/2023 in #fix-my-print
Ringing on only one side of the print?
28 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 1/20/2023 in #ratos-support
Can't SSH into pi with ratos 2.5 alpha
4 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 1/11/2023 in #ratos-support
Can't connect to wifi
12 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 1/2/2023 in #fix-my-resonance
Help with x resonances
36 replies
RRCRat Rig Community [Unofficial]
•Created by Bameron on 12/4/2022 in #fix-my-printer
Flow issues
im having some extruder skipping at fairly low flow rates, i just switched to some polymaker polylite petg, and i can only consistently hit 25mm^3/s at 260c
orbiter v2 and dragon UHF, is this a hardware problem, or does polymaker petg just not print fast?
3 replies