Can't connect to wifi
Whenever I open the link to connect a network, it just loads endlessly. I need to connect to be able to set up the usb toolboard.
6 Replies
does your Pi have wifi ? or you can connect using ethernet as well
You need RatOS v2 alpha for toolboard support.
Ah
But this isn’t the toolboard link, it’s just the wifi setup
It worked perfectly fine like a couple weeks ago
@miklschmidt fixed all connection issues by setting my timezone correctly in the pi...
updating to ratos v2 alpha now
i followed this diagram, but the pt1000 was only accurate when i removed the jumper for the temp sensor
i have a pt1000, but i didn't need to use the jumper
You need the jumper to change the resistor on the thermistor port, in which case you need to add the resistance to your config. It’s much recommended you do that.