gywilo
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/6/2024 in #ratos-support
MCU shutdown; timer too close
6 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 2/21/2024 in #fix-my-print
underextrusion- due to retraction?
4 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 10/29/2023 in #fix-my-print
over extrusion and under extrusion on the same print
10 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 10/24/2023 in #fix-my-print
Warping at support interface on large print
1 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 10/12/2023 in #fix-my-print
layer cracking
11 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/14/2023 in #fix-my-print
ripping/tearing of first few layers in one local spot on large print.
15 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/10/2023 in #fix-my-print
1st print great, 2nd print cracking/seperation
15 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/2/2023 in #fix-my-resonance
fix resonance
23 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/2/2023 in #fix-my-printer
4028 always 100%
2 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 9/2/2023 in #fix-my-print
subtle wavyiness surface finish
7 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 8/6/2023 in #fix-my-print
new filament, gaps in layers
25 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 8/5/2023 in #fix-my-print
Filament runout/restarting woes
10 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 7/28/2023 in #ratos-support
config.cfg warning, not viewable
12 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 12/2/2022 in #fix-my-print
blurps or zits or bumps showing on exterior
11 replies
RRCRat Rig Community [Unofficial]
•Created by gywilo on 12/1/2022 in #ratos-support
forget or re enter wifi credentials
Is there some way to forget or re enter wifi credentials after setup?
28 replies