Champ180 Posts - Answer Overflow

Champ180

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 2/6/2025 in #fix-my-print

Bad top surface quality

4 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 2/4/2025 in #ratos-support

Nothing working after latest update

8 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 1/20/2025 in #fix-my-print

Print to squished on 1 side & loose on the other

2 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 1/12/2025 in #ratos-support

Prime blow messing nozzle

I have just upgraded to the latest RatOS. I have always used my own Start_Print macro but I wanted to use the default one now as it is much better. The issue I have is the prime blob. The nozzle is too deep into the blob & when the prime blob is finished the nozzle is covered in plastic. Is there a way to adjust the height of the nozzle for the prime blob without messing up the whole start_print macro?

4 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 12/10/2024 in #fix-my-resonance

Belt tension & shaper graphs

2 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 12/10/2024 in #ratos-support

Belt tension & shaper graphs

9 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 10/17/2024 in #ratos-support

How can I comment out Beacon surface scanner?

For some reason I can no longer connect to my Beacon Rev H mcu. I would like to comment this out for now so that I can test a new fan install but klipper will not do anything when it cannot connect to the Beacon mcu. Is it possible to temporally comment out the Beacon? I tried commenting out the [include RatOS/z-probe/beacon.cfg] in RatOS.cgf but it must be mentioned somewhere else also as I just get Unknown config object 'beacon'

5 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 10/13/2024 in #ratos-support

separate LED circuits?

Is it possible to add 2 separate LED circuits to the Octopus pro? I have the chamber lights on the RGB port but want to add another separate set of ARGB LEDs to control separately to the chamber LEDs.

2 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 9/18/2024 in #ratos-support

limit speed

How do I reduce the max speed & accel. I have added the following to my printer.cfg file. The overall limits appear to have set OK but my bed mesh & Z-tilt are still trying to move too fast. The problem is I have changed the motors to LDO 2804s thinking that they had more speed but they simply do not have the power / torque for the VC-500. So I have to limit the speeds to be able to use it at all untill I get replacement motors. [printer] max_velocity: 300 max_accel: 3000 [bed_mesh] speed: 300 [z_tilt] speed: 300

10 replies

RRCRat Rig Community [Unofficial]

•Created by Champ180 on 8/18/2024 in #ratos-support

Stopped connecting to wifi