How can I comment out Beacon surface scanner?
For some reason I can no longer connect to my Beacon Rev H mcu.
I would like to comment this out for now so that I can test a new fan install but klipper will not do anything when it cannot connect to the Beacon mcu.
Is it possible to temporally comment out the Beacon?
I tried commenting out the [include RatOS/z-probe/beacon.cfg] in RatOS.cgf but it must be mentioned somewhere else also as I just get Unknown config object 'beacon'
2 Replies
What version of RatOS are you using? 2.0 or 2.1?
The error after commenting the line is from the overrides section on printer.cfg, at the bottom
Use the hardware configurator and pick a different probe and then remove all traces of beacon settings from the klipper config block at the end of printer.cfg