Resonance test has gone haywire!

So for an unknown reason I was getting an error "Invalid adxl345 id (got ff vs e5)" when I tried a new resonance test with my Beacon. I set up my VC3.1-500 with stock performance RatOS config including the beacon. After reading up on the above error it looked like my accelometer was set to an ADXL toolboard so I added this to my printer.cfg
accel_chip_x = beacon
accel_chip_y = beacon
accel_chip_x = beacon
accel_chip_y = beacon
` Now when I do a resonance test the print head moves about ±30mm on the X??? Any ideas?
0 Replies
No replies yetBe the first to reply to this messageJoin

Did you find this page helpful?