Prime blow messing nozzle

I have just upgraded to the latest RatOS. I have always used my own Start_Print macro but I wanted to use the default one now as it is much better. The issue I have is the prime blob. The nozzle is too deep into the blob & when the prime blob is finished the nozzle is covered in plastic. Is there a way to adjust the height of the nozzle for the prime blob without messing up the whole start_print macro?
2 Replies
MDFPereira
MDFPereira2mo ago
Hello. Please share the requested files. For starters, are you using the recommended start code on the slicer? Isn’t your bed lowering while doing the start print blob? If yes, the blob should stay in the bed. This will clean all the remaining plastic on the outside of the nozzle.
AsicResistor
AsicResistor3w ago
I'm having a similar issue, using a 0.6 nozzle the blob is way too big, when lifting the whole thing stays attached and ruins the print

Did you find this page helpful?