guesswhatsthisparlor
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 7/29/2024 in #fix-my-printer
Y Axis (maybe x too?) not moving
As the video shows, the Z- Axis moves, but the rest doesn't. I think I did something wrong in the belts
3 replies
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 7/24/2024 in #fix-my-printer
MCU Protocol Error
Basically, I'm getting the following errors
17 replies
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 7/24/2024 in #fix-my-printer
Password is not raspberry
Basically I tried to ssh to my pi and the password isn't raspberry. I don't remember changing anything and I'm an idiot, so yeah
15 replies
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 7/19/2024 in #fix-my-printer
Octopus Pro V1.1
Basically, it refuses be detected AND have Klipper. When I flash it through DFU, it says that it doesn`t have Klipper and when I try through microSD card, I refuses to be detected
26 replies
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 7/14/2024 in #fix-my-printer
EBB42 not going into DFU mode
The board is connected but not detected. I try putting it into DFU mode, but nothing happens
17 replies