Part Cooling fan doesn't work
Cable checks out. Tried to change the pins without success. Put it to 100% but it doesn't move
No idea what to do
6 Replies
It becomes power
But it doesn't move
Tried switching the pins in the config and nothing
Like
fan_part_cooling_pin: PA8 to toolboard_t0:PA0
I played around in the configurator but it still doesn't do anything
You're talking about the 4020 fan, right? As long as it has power, it should be running. Only if it has power AND a proper pwm signal will it stop. So id triple check that it has a valid power and ground connected and the correct voltage.
It's on the right voltage
12V
Is that voltage making it all the way to the fan?
Yes
Swap the fan then, cause if it is getting power and ground it should be going 100%