Mikey Comments - Answer Overflow

Nope, Look at the first video, its clean in the x axis and y axis both ways. Only silly when you ztilt and it does that madness. I'm leaning towards a cooked driver sinfe i would think a manual move is not as fast as the z tilit initialted.

14 replies

RRCRat Rig Community [Unofficial]

•Created by Mikey on 1/2/2025 in #fix-my-printer

Upgraded my toolhead on RR3.1 and the printer has gone full stupid.

Grinding Ztilt

14 replies

RRCRat Rig Community [Unofficial]

•Created by Mikey on 1/2/2025 in #fix-my-printer

Upgraded my toolhead on RR3.1 and the printer has gone full stupid.

Homing okay

14 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

Mine was doing the same and I reduced the EM a bit. What material are you printing and whats the EM?

134 replies

RRCRat Rig Community [Unofficial]

•Created by Mikey on 11/19/2024 in #fix-my-print

Commissioning - Ripples in first layer

I appreciate you, thanks!!!

4 replies

RRCRat Rig Community [Unofficial]

•Created by l4ndm4n on 10/31/2024 in #fix-my-mesh

Commissioning V-Core 4 Idex

.124? I'd say send it!

4 replies

RRCRat Rig Community [Unofficial]

•Created by Mikey on 6/16/2024 in #fix-my-print

Horrible Top Layer and a groove?

Its Polymaker PETG at 238 - My prusa loves it there, and I can bump up cooling but Polymaker it cool from 0-20% fan. I'll try again. I ran the belt tuner and they were decently out of alignent so I'll report back shortly

5 replies

RRCRat Rig Community [Unofficial]

•Created by Mikey on 5/28/2024 in #fix-my-printer

Dua 5015's always running - but not in the interface

Edit, I accidentally used the "controller fan" pin for the second fan. Moved it to another port and all works as expected.

4 replies

Gaming

Programming