Mikey
RRCRat Rig Community [Unofficial]
•Created by Mikey on 1/19/2025 in #fix-my-printer
VCore 4 500 - "Died mid-print, got an ADC out of range now. Thermistor tests 1.074 kOhm
4 replies
RRCRat Rig Community [Unofficial]
•Created by Mikey on 1/2/2025 in #fix-my-printer
Upgraded my toolhead on RR3.1 and the printer has gone full stupid.
Gong to the commissioning steps and it seems to "home" okay but when I run z-tilt, it's making awful noises almost like I have a stepper backwards. I have checked all the cables, and I am at a loss as to what could be the difference between the two. Also sometimes, when trying the z tilt, the console shows no trigger after full movement, but the pinda is way off the plate either forward or off to the side.
Now I did have the controller fan off, is it possible I nuked a driver?
14 replies
RRCRat Rig Community [Unofficial]
•Created by Mikey on 11/19/2024 in #fix-my-print
Commissioning - Ripples in first layer
4 replies
RRCRat Rig Community [Unofficial]
•Created by Mikey on 6/16/2024 in #fix-my-print
Horrible Top Layer and a groove?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Mikey on 5/28/2024 in #fix-my-printer
Dua 5015's always running - but not in the interface
4 replies