Maba_Kalox
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 6/10/2023 in #ratos-support
How to use tuning tower for speed calibration?
Hi, I would like to somewhat automate speed tuning, but I am not sure how to combine M220 GCODE and TUNING_TOWER klipper command.
24 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 6/7/2023 in #fix-my-print
belt ripples artifact
162 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 6/5/2023 in #fix-my-resonance
double peaks on Y
9 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 6/5/2023 in #fix-my-printer
Can't equalize belt tension
23 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 5/2/2023 in #fix-my-mesh
Did I bent the bed? (300mm)
36 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/29/2023 in #ratos-support
disable "debug set kinematic position" in mainsail
How to disable this debug macro properly? I already once accidentally clicked it, and crashed bed into the print-head...
3 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/24/2023 in #fix-my-printer
Uneven belts tension and square xy
146 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/18/2023 in #fix-my-resonance
Resonance at 125hz
8 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/16/2023 in #fix-my-mesh
Is it good enogh?
23 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/1/2023 in #ratos-support
fly-sht-36 support
77 replies
RRCRat Rig Community [Unofficial]
•Created by Maba_Kalox on 4/1/2023 in #ratos-support
SKR 1.3 support
5 replies