Is it good enogh?
Hi, I just finished basic setup of my V-Core 300mm and run a bed mech, does it looks good? What could be improved? Question is quite dumb, so - feel free to throw some useful doc/video which will answer my question.
17 Replies
0.133mm variance is not too bad in my opinion, but could be improved. Is this with enclosure, heated bed or cold?
cold, no enclosure
and magnetic sheet i take it?
yep, ratrig PEI sheet is on, sensor - bltouch 3.1
have you watched this?
https://www.youtube.com/watch?v=h7ZTq2dDTkM
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
I saw it, but was not sure - would I like to bother or not, so I first desided to ask - "is it good enough"
good enough depends 😉
on your wishes, desires, application
I have pretty bad printed parts (which I managed to damage during assembly), which makes belt go up and down, so current goal - is it good enoght to reprint parts for itself
xD
well obviously I cant judge that ... but if all stays as it is, 0.133 variance is perfectly capable of correction through a bed mesh
okay, I will check with heated bed to 80C
leave it for 15 to 30 minutes and check again, without enclosure Im not sure but I dont think it will matter much after that
did not get a lot worse after 15min I guess
It got a lot better as I suspected.
wait - it got - better?
Ranged increased a bit, I dont understand - where did it become better xD
sorry no i was on my phone and misread
still 0.15 is quite good
In my opinion, yes, that is good enough... .15mm variation over 300mm... Ask yourself, do you need greater precision than this for parts that large?
There are many other factors that will affect your print quality far more than making you mesh any better than it already is
Thanks for help!