Naiofz91
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 8/8/2024 in #fix-my-print
1'st layer issue
5 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 12/2/2023 in #fix-my-print
underextrusion.
1 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 9/12/2023 in #fix-my-resonance
Error trying to activate ADXL setting on klipper.
after uncommenting the ADXL part, i get this error "" Unable to parse option 'pid_Kd' in section 'heater_bed'
""
the heater bed works fine except i cant get adxl working ...
5 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 9/6/2023 in #fix-my-printer
ADXL app. correlation
7 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 9/5/2023 in #fix-my-printer
connecting 4 pin controller fan
hey there, how do we manage connecting 4 pin controller fan to the ooctopus 466, and what are the cfg needed for so.
thank.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 9/2/2023 in #fix-my-printer
" Endstop z still triggered after retract "
hello there, swapped boards, and got to initial set up, when trying to calibrate z, its showing "" Endstop z still triggered after retract
"
checking the trigger statue, X is open, Y is open, Z and probe says triggerd, although its far away, and the only motion i got was downward and then the error message, i tried to add a " ! " instead of the " ^ " on the line, the stautes became open for all 3 axis and probe, but it crashes and doesnt detect the bed upon calibration.
check cables and all and it looks right.
9 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 5/20/2023 in #fix-my-printer
trouble connecting multiple " Controller Fans "
got rat-os running, when trying to ramp up speeds, kept getting over heating errors. so i tried connecting multiple fans but started getting other error codes.
1 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 5/4/2023 in #fix-my-mesh
Mesh Bed Everywehre.
1 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 2/18/2023 in #fix-my-print
underextrusion upon 1'st print test cube.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Naiofz91 on 2/16/2023 in #ratos-support
printer fails to detect bed upon mesh leveling " No trigger on probe after full movement "
i reflashed firmware n did the installing all over, machine homes well, and z tilt works, yet upon trying to start a print, on mesh leveling far left, the probe falls outside of the bed space and crshes into bed and i get no trigger after full movement.
29 replies