toml
RRCRat Rig Community [Unofficial]
•Created by toml on 3/3/2025 in #fix-my-printer
Linear rail not sitting flat
4 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 2/14/2025 in #fix-my-printer
'Extremely twisted gantry'
12 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 2/12/2025 in #fix-my-printer
2.1 RC3 configurator can't flash board(s)
Fresh install of the new RatOS, brand new Sandisk card from Amazon.
Pi4
BTT Octopus Pro H723 v1.1
Ethernet
Can see MCU is connected in
/dev/serial, along with the EBB42.
Configurator can't seem to detect the board for some reason, so won't flash them.
Hoping to resolve it as the primary reason from switching from my old 429 board was to allow automated flashing, and not having to use my dfu-util flashing script anymore.
Debug.zip attached.
Followed the process outlined in the RatOS docs ref. updating via mainsail prior to proceeding with the configurator beyond wifi setup.
RatOS --> RatOS configurator --> updated all others.19 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 9/2/2023 in #fix-my-resonance
anything to do?
2 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 5/22/2023 in #ratos-support
Webcam is broken after Crowsnest update
Mainsail have shipped a Crowsnest update that requires manual intervention:
See Mainsail support thread: https://discord.com/channels/758059413700345988/1110268408299270255
35 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 5/14/2023 in #fix-my-print
too close to bed?
2 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 5/8/2023 in #fix-my-print
Weird artefacts on perimeters
3 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 5/3/2023 in #fix-my-resonance
Input shaper still quite messy after lots of work
4 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 4/23/2023 in #fix-my-printer
MG995 Servo causing error and beeping
Ya’ll. Struggling to add an mg995 servo to my rig.
Using the BLTouch pins, the servo initially moves to the initial_angle set position but the MCU (octopus) then disconnects and beeps constantly. I’ve tried using one of the endstop pins for the pwm signal instead (PG11) and got the same result. Have crimped and recrimped the connectors. There’s no error per say in the Klipper logs either. Just get an ‘EOF’ error.
Using the BLTouch pins, the servo initially moves to the initial_angle set position but the MCU (octopus) then disconnects and beeps constantly. I’ve tried using one of the endstop pins for the pwm signal instead (PG11) and got the same result. Have crimped and recrimped the connectors. There’s no error per say in the Klipper logs either. Just get an ‘EOF’ error.
24 replies
RRCRat Rig Community [Unofficial]
•Created by toml on 4/3/2023 in #fix-my-print
ASA bridging.
47 replies
