Volgger
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/28/2025 in #fix-my-resonance
Aweful Graphs .... regardless what I'm trying :-(
2 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/14/2025 in #fix-my-printer
IDEX Head collision while heating up
sorry, I think I posted this in the wrong channel .... I think it's an printer issue, not a RotOS issue...
https://discord.com/channels/582187371529764864/1350126532214919168
11 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/14/2025 in #ratos-support
IDEX head collision while warming up!
Hi there,
I'd just finished my Vcore 4 400mm Idex and wanna print a dual color dice. After homing, when both heads "meet" in the bed center for heating up, the T0 moves a bit to the left and when T1 comes in, it bumps hard against T0 loosing some steps. The result is an offset in X of about 3mm!!! tried serveral times - always the same issue. 😦
10 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/14/2025 in #fix-my-printer
Strange noise :-)
Dear all,
Do anyone out there hav so similar noises during low speeds? Seems to come from back left, but I cant finde the Problem 😦
5 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/10/2025 in #fix-my-printer
Very stange Bed Mesh ....
5 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 3/6/2025 in #ratos-support
502 Bad Gateway
Dear all, I'm struggeling with an "502 Bad Gateway" error since I've updated the whole RatOs after configuration, when I'm trying to open "Configurator", "Realtime Analysis" and "VAOC". It just shows a "white page" with the error.
Anyone any idea, what I'm doing wrong?
Thank you so much, Volker
11 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 1/17/2023 in #fix-my-printer
Skew Correction?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Volgger on 1/13/2023 in #fix-my-resonance
VCore 3.1 300mm - reason for second peak on Y-Axis???
33 replies