IDEX head collision while warming up!
Hi there,
I'd just finished my Vcore 4 400mm Idex and wanna print a dual color dice. After homing, when both heads "meet" in the bed center for heating up, the T0 moves a bit to the left and when T1 comes in, it bumps hard against T0 loosing some steps. The result is an offset in X of about 3mm!!! tried serveral times - always the same issue. 😦
7 Replies
I grinded off a lot, but still there is a collision, loosing steps😵💫
Those are not the IDEX ducts IIRC.
Solution
They're different for a reason
You just bumped into that reason 😄
Yes I'm stupid like hell😂 Already changed the ducts