IDEX Head collision while heating up
sorry, I think I posted this in the wrong channel .... I think it's an printer issue, not a RotOS issue...
https://discord.com/channels/582187371529764864/1350126532214919168
7 Replies
Did you self source your print files or get them direct from ratrig?
@Volgger regardless, I can tell you have the non-idex fan shrouds. The idex fan shroud are different and have a shallower width
@Wetson oh my god, I'm so stupid😵💫 I mixed up the files .... thank you so much for yor help👍 💪
Btw ... you are using the Toro titan tube? I replaced it by the original one, because my one was extremly uneven.😬 Is you mesh okay ?
Mesh is sub 0.1mm deviation regardless of temps.
Did you try levelling with kapton tape? Ti tubes are just hard to manufacture straight. So there's some adjustment needed
No not yet - need a working printer, so i changed back to original for now .... but I'll give it a try. I marked the positions, so it's easy to prepare.
I would highly highly highly recommend the Ti tube even if it takes some tinkering, especially if you have an enclosed printer
Yes my printer is enclosed, thats why i already bought the ti tube.