Wetson Posts - Answer Overflow

@YeagerBomb Starting it here so we can keep track, since your messages seem to be getting lost again going to ask: i am following the IDEX commissioning guide. I have done everything up to __vaoc_reset. When i go to VAOC and hit start calibration it drives my print heads to the fron of the machine NOT the rear. I can not move the print head with out error and the VAOC calibration only allows me to change Z height. What am i missing. How do i set the camera location?!!! Could you please, firmware reset your printer, take a video and record what happens on your printer when you press the home button on the RatOs dash? I want to see if it is homing in the correct direction

6 replies

RRCRat Rig Community [Unofficial]

•Created by Wetson on 1/2/2025 in #ratos-support

IDEX Mirror "Move Out of Range"

Have ran into this three times now. Print will start successfully before running into a "Move out of Range" error on the first layer even though there is still a decent chunk of room left between the heads. I have followed the EndStop Calibration as described in the comissioning guide exactly, and even ran a VAOC calibration before the print. I tested with IDEX COPY and that worked, however I need mirror for these parts. IDEX Mirror also failed on a previous print (different model) that was 0.30mm below the size limit, however I assumed I was just too close. Potentially related. Attached is the Debug zip from the most recent failed print. As well a short video, hopefully you all can help! Love the printer. Thanks!

111 replies

Gaming

Programming