12 Replies
Internal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrationsTestGenerator'
Once the underlying issue is corrected, use the "RESTART"
command to reload the config and restart the host software.
Printer is halted
This pop up after updating everything
-----------------------------------------------------------------------------------------------------------
Using the update everything can break things. Try and reboot the PI and see if there's any updates left
sorry, I mean restart MoonRaker, though rebooting the Pi should do the same
@guesswhatsthisparlor
Let me know how it goes, moved it here for relevance
fatal: unable to checkout working tree
warning: Clone succeeded, but checkout failed.
You can inspect what was checked out with 'git status'
and retry with 'git restore --source=HEAD :/'
Git Repo ratos-configurator: Git Clone Failed
Error Recovering ratos-configurator
Git Clone Error
Corrupt ratos configurator
Did you try the git restore line?
this is a little out of my wheelhouse
Will try it
Additionally, if that doesnt work, you can try to SSH into your pi and use RatOs doctor to clean things up.
https://discord.com/channels/582187371529764864/1330240060519616512/1330352236139646997
Well, the ssh refused to connect
Did it
Let's see what happens
The board is running version v0.12.0-316-g96cceed2 but you your pi is on version v0.12.0-316-g96cceed23. If you want to update your board click 'flash again' below.
my mcu
I flash it again and again and it just doesn't change
my toolboard too
MCU 'mcu' shutdown: ADC out of range
Sensor 'heater_bed' temperature -109.280 not in range 0.000:140.000
This generally occurs when a heater temperature exceeds
its configured min_temp or max_temp.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
I shouldn't install it yet
oh you do need the heater bed thermistor plugged in in order for this to all work
Ok
Well, the ratos configurator is still gone, but everything else is working
Ratos configurator is gone from...?
Sorry, I meant is still corrupt
It's weird, there are 2 ratos configurator repository, one is normal and the other is corrupt
May have to keep trying a reboot/restart cycle to try and get it to work. Additionally another ratos doctor. Those are about the only two strategies I have right now without reflashing lol
ratos doctor doesn't work