Anrot
RRCRat Rig Community [Unofficial]
•Created by Anrot on 11/18/2024 in #fix-my-printer
VAOC calibration gives error: Move out of range
Hello,
Calibration of VAOC dos always give an "Move out of range: 86.941 661.862 39.000 [0.000]" erorr. Tried to follow the commission guide but this porcedure doesn't work any suggestions how to get IDEX working?
105 replies
RRCRat Rig Community [Unofficial]
•Created by Anrot on 10/21/2024 in #fix-my-printer
Vaoc - not working
Hello,
tried to get VAOC cam working, unfortenately it doesn't show anything.
In the Vaoc tab it only shows "Webstream not found"
I followed the official intruction guide and the Commissioning Guide.
Tried also to get a usb cam and a raspbery pi cam working, both failed to work.
63 replies
RRCRat Rig Community [Unofficial]
•Created by Anrot on 10/16/2024 in #fix-my-resonance
VC4 Idex Belts
1230 replies
RRCRat Rig Community [Unofficial]
•Created by Anrot on 10/14/2024 in #ratos-support
Error evaluating 'gcode_macro START_PRINT:gcode': gcode.CommandError: Something went wrong! Missing
Hello I get this error: Error evaluating 'gcode_macro START_PRINT:gcode': gcode.CommandError: Something went wrong! Missing
Already tried the fix which is in the Forum but I didn't have the code which would be the problem.
I also tried this: https://github.com/HelgeKeck/RatOS/blob/documentation_v2.1/site/docs/slicers.md#prusa-slicer
And tried to with pruas and orca slicer.
Always the same error.
Attached the printer.cfg and RATOS.cfg
Please help with this issue.
13 replies