Perfect First layer, disasterous second

Hello, My first layer is almost perfect but the second is an absolut mess. The building plate is preheted to avoid temperatur issues also tried different slicer settings. But it seems ratos shifts the second layer. Does anyone know how to solve this issue?
No description
1 Reply
abcurrie
abcurrie3d ago
Usually the first layer is printed much slower than others and cooling usually turned off. I would check to see if the 2nd and higher layers speeds are too high, then if filament temp is too low , or the cooling is too high. The 2nd layer starts out OK but that is because the lines are short. Once the lines get longer, the printer can't keep up with the speed.

Did you find this page helpful?