~ bitbash
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/29/2025 in #fix-my-print
Temperature tower curl/lift
Don’t know what I’m doing wrong here, if it’s too much cooling and it’s curling, or if it’s not enough cooling since it seems soft…
I’m out of ideas.
The print gets knocked out the bed minutes later because of this.
Printing pla.
If anyone has a good config between nozzle temp and cooling for a base let me know
Running 0.6 nozzle
7 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/28/2025 in #fix-my-print
Pressure Advance Tower Problem
6 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/28/2025 in #fix-my-resonance
Better results with Mirror/Copy than Single? 500 IDEX
5 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/26/2025 in #fix-my-printer
Belt aligned help
Is there any reason why this is happening?
When I move my T0 right, the belt aligns itself, when I move it to the left it kinda gets down.
So I feel resistance when i move it left but not when moving right.
I already made sure everything was ok in the bearings/pulleys etc, already loosened the belt and tighten, nothing works, any suggestions?
7 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/25/2025 in #fix-my-resonance
A lot of noise and spikes on Y
8 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/17/2025 in #ratos-support
Sensorless ENDSTOP problem
2 replies
RRCRat Rig Community [Unofficial]
•Created by ~ bitbash on 1/15/2025 in #fix-my-printer
Negative temp readings from Octopus V1.1 F446
23 replies