Temperature tower curl/lift
Don’t know what I’m doing wrong here, if it’s too much cooling and it’s curling, or if it’s not enough cooling since it seems soft…
I’m out of ideas.
The print gets knocked out the bed minutes later because of this.
Printing pla.
If anyone has a good config between nozzle temp and cooling for a base let me know
Running 0.6 nozzle
6 Replies
Its lack of cooling but when I do the proper cooling, the right side piece breaks
90% cooling works but strings like crazy.
20mm/s max volumetric speed.
Yes like you say
To less cooling or to fast or to high temperature
Stringing maybe because of wet filament ? Do you dried it Before printing ? What filament is it ?
if you have an encloser open the doors PLA likes to be in a room temp environment, closed chambers make it too soft