~ bitbash Comments - Answer Overflow

I use smooth plate/high temp plate with chamber at 60°C on my bambu, I can print whatever without warping. I only use 3DLac, a good layer will last you forever

25 replies

RRCRat Rig Community [Unofficial]

•Created by skyline131313 on 3/29/2024 in #fix-my-printer

Z wobble or some sort of problem with gantry?

Is your nozzle/whole print head wobbly? Did you tighten the X axis belt? Does your lead screws have any room to compensate the vibrations? Oldham couplers with anti backlash can help there. Did you tried to print a little slower to see if the issue persists? Did you tuned/calibrated your filament? Temp, flow rate etc? Is your z offset properly tuned? So it isnt too low/too high? There’s a lot of variants here, those are some I could think of

6 replies

RRCRat Rig Community [Unofficial]

•Created by YouvBeenThumped on 3/30/2024 in #fix-my-printer

Belt tension or something else?

Same concept, kind of 😂😂

10 replies

RRCRat Rig Community [Unofficial]

•Created by YouvBeenThumped on 3/30/2024 in #fix-my-printer

Belt tension or something else?

https://tenor.com/view/red-velvet-red-velvet-cupcakes-icing-icing-cupcakes-cream-cheese-frosting-gif-12382602

10 replies

RRCRat Rig Community [Unofficial]

•Created by YouvBeenThumped on 3/30/2024 in #fix-my-printer

Belt tension or something else?

Z offset too low or over extrusion. This waves are caused because you are extruding more than the distance between nozzle and bed can take, so it doesn’t go sideways it goes up causing waves. I would recommend you to print the same square and adjusting your z offset on the go. @YouvBeenThumped

10 replies

Gaming

Programming