ThatLadBoniface Posts - Answer Overflow

ThatLadBoniface

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 12/3/2023 in #fix-my-print

strange lines of low flow

4 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/19/2023 in #fix-my-mesh

Why is this happening?

9 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/8/2023 in #fix-my-resonance

Belt Tension Check

4 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/31/2023 in #fix-my-resonance

ADXL burnt out?

43 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/30/2023 in #fix-my-print

sketchy layers

1 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/23/2023 in #ratos-support

MCU unable to connect

This is a really challenging issue. I have read all the posts about the octopus V1.1 that cannot connect and say they have a configuration error and cannot connect to klippy I have tried all the methods, new cables, new USB and I think the issue is configuration related but I can’t figure out what. Right after I flash my board I get the “octopus pro h723 v1.1 is detected but unresponsive”, but when I connect to pi via ssh and connect to the board to identify itself it communicates that it is connected to an h723. I can supply screenshots if needed. Not sure what to do? Should I flash something via the SSH command prompt? I have followed the steps in printer.cig, wired it up, unwired, im about ready to get a new board but I am not convinced there is anything wrong with the board.

66 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 3/21/2023 in #fix-my-mesh

V-Core 500, To Sag or Not To Sag?