ThatLadBoniface Comments - Answer Overflow

ThatLadBoniface

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 12/3/2023 in #fix-my-print

strange lines of low flow

i fixed it, it was bad retraction settings

4 replies

RRCRat Rig Community [Unofficial]

•Created by cm on 8/29/2023 in #fix-my-mesh

BL-Touch Failed To Deploy

can you elaborate on this a little more? i have start started to have the same issue

4 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/19/2023 in #fix-my-mesh

Why is this happening?

consider trying BLTouch if able, between the steel sheet, magnetic sheet, aluminum plate, magnets in the corner, and metals in the hotend mere milimeters from the sensor, i didnt see that the readings from pinda were consistently triggering at an accurate height,as opposed to a solid click from the touch prob. I have no data nor detailed explanation more than the days of frustration that was solved by switching

9 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/19/2023 in #fix-my-mesh

Why is this happening?

what probe are you using? i gave up on using a PINDA probe and went back to a bltouch

9 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/19/2023 in #fix-my-mesh

Why is this happening?

for those interested the solution is more probe points

9 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/19/2023 in #fix-my-mesh

Why is this happening?

9 replies

RRCRat Rig Community [Unofficial]

•Created by C7H on 6/29/2023 in #fix-my-mesh

Printer not follow bed mesh

im currently having the same problem, print failed because the nozzle started dragging on the bed despite having an active bed mesh

19 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 9/8/2023 in #fix-my-resonance

Belt Tension Check

4 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/31/2023 in #fix-my-resonance

ADXL burnt out?

does the Z have to be below 100 when i do a MEASURE_AXES_NOISE? its at 159

43 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/31/2023 in #fix-my-resonance

ADXL burnt out?

It was what you suggested plus the PA15 thing because that that time the CS pin was assigned to something else, what specifically i don't know, and yes there was some sketchy wiring at various points but i also fixed some bad connections

43 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/31/2023 in #fix-my-resonance

ADXL burnt out?

i think i passed the learning curve on this particular thing

43 replies

RRCRat Rig Community [Unofficial]

•Created by ThatLadBoniface on 8/31/2023 in #fix-my-resonance

ADXL burnt out?