azoroes
RRCRat Rig Community [Unofficial]
•Created by azoroes on 10/10/2024 in #fix-my-printer
Printer going totally wrong while Z-Tilt
Hey Guys,
I set up my Vcore 3.1 500 englosed from stock, as I got some problems beforehand.
I used RatOs 2.1, followed the instructions to first update everything (so its on RC3 now), did the setup wizard, added a few small things from my previous setups (nothing thats connected to the motion systems, just light, the command for the fan and a additional temperatur probe).
I did the beacon_calibrate and just wanted to start my first print so far and X/Y/Z-Homing was totally fine, but as soon as it started the z-tilt the whole motion of the extruder was completely off and also making noices I never heared from a printer before!
I'll attatch a video from what I was able to catch before I had to emergency-exit it.
It's a Vcore 3.1 500 with stock drivers, stock stepper motors and using the "normal" configuration even if it has two additional 40mm noctua coolers on top of the stepper drivers.
Any ideas how this could happen and how to fix it?
14 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 5/24/2024 in #fix-my-print
First Layer problems
4 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 2/28/2024 in #fix-my-print
Severe first layer problems
6 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 12/26/2023 in #fix-my-mesh
VCore 3.1 500 high mesh range
3 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 11/23/2023 in #fix-my-printer
4028 Fan not working correctly
Hi, just setting up my printer
Wired everything as shown on the 4028 ratos site and tried every single code.
My problem is that in every setting the fan is on at 100%
Only exception is if the enable pin is set as shown the fan runs if set to 0%
If I go anywhere between 1-100% it's completely shut down.
Any ideas?
8 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 11/20/2023 in #ratos-support
Solved: BTT Smart Filament Sensor 2.0
Hey,
Is there already a matching config for the version 2 of the BTT Sensor?
And has someone already figured out how to connect it to the octopus 1.1?
Thanks a lot,
Alex
#bigtreetech #smartfilamentsensor #smartfilamentsensor2.0
#octopus1.1 #btt
4 replies