Severe first layer problems
Hey guys, i have a pretty big problem with my first layer and I really don't know what to do
I first thought it's a problem of to less bed mesh so I upgraded my toolhead with a beacon Rev H and a 100x100 bed Mesh on my 500x500mm bed (and using adaptive meshing) but it still dosen't work.
Every time I print the brim is totally fine but then the nozzle gets closer and closer until it stops due to no filament is getting pushed forwards.
Can anybody help?
4 Replies
Maybe late, but that spot on heightmap looks like something is stuck under the bed. Also try folium on the right side
And I would check slicer config. The height should affect brim and its not causing problems there. Height problems should impact everything on the first layer. Are you printing too fast for first layer? Too slow? I would start with fresh standard slicer config and work from that up
I'll Try resetting my slicer with a new profile, I already thought if the brim is printed another height but I'm not sure how this could be changed (at least in orca)
First layer is standard 50mm/s
The spot on the printbed is badly always there but by taping one section I was able to get the total of nearly 0,9mm down to 0,4 over the whole 500*500 bed
Several layers of tinfoil works like magic, I tell ya. My original tram was 0.148, not it's 0.069 and that is only die to.one high corner maybe because of how I glued