MISSION CRITICAL
RRCRat Rig Community [Unofficial]
•Created by MISSION CRITICAL on 4/10/2024 in #fix-my-printer
Z TILT is never perfect
Hello everyone. I would like to ask you what would the best coordinates for z tilt probing?
I am trying to improve how my vcore 3.1 does this procedure as I always find one corner os the bed a bit too raised and by consequence, the other is always a bit too low.
I know its a problem with this because when I calibrate with paper below the klicky probe, It levels perfectly, so, its not a warped bed.
Thank you all in advance
2 replies
RRCRat Rig Community [Unofficial]
•Created by MISSION CRITICAL on 1/10/2024 in #fix-my-printer
Endstop z still triggered after retract
Hello everyone.
There is an issue in my printer keeping me from sleeping at night, the Z probe and its homing.
My setup is:
I have a Ratirig Vcore 3.1 with octopus 1.1 and EBB36
I use a manual Klicky probe, NON stowable klicky probe, the kind that is manually inserted in position before homing and then manually removed right after.
The software is RATOS and during install I flashed both the octopus and EBB for updating the whole thing. RATOS and its components have also been updated just in case and still, not working.
24V
TMC 2209 for all the motors, wich are LDO's
USB link between rapberrypi 4 and the EBB36
USB link between raspberry pi 4 and octopus
USB link between touchscreen and raspberry pi
Problem:
"Z Endstop still triggered after retract "- That is the message I get after trying to home Z
I can NOT home Z axis, but X and Y Home just fine.
My troubleshooting:
I find the probe of Z axis is always triggered, if I press the switch, or not, if I disconnect the cable from toolboard to switch, or not. Don't know why but seems to be always on.
I dont know if its the EBB36 reporting to klipper a wrong status or not detecting the switch in clicky. Both the Klicky, EBB36 and octopus have worked before in a diferent software configuration in the past.
I am sorry if this message is being posted in the wrong place or if it has been discussed before, elsewhere and I missed it.
This problem should be the very last one to solve to get my printer working again. I am stuck in this situation because of a software update that caused all my printer OS to be corrupt and never worked again since.
Thanks in advance for the gentle souls willing to look into this issue with me.
3 replies