Dante Tango
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 11/2/2024 in #ratos-support
MCU Timing Error
Consistently getting a timer too close error, about 45 seconds into prints- Tried two different pi's, with and without camera attached. V3.1 running 2.1, issue started 2 updates ago.
14 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 4/23/2024 in #fix-my-resonance
Toolhead Beta-400
8 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 10/8/2023 in #fix-my-printer
Bed Not Heating
Yesterday I finished a print, everything seemed normal, printing at 70c bed temp. My next print that day, the bed started warming but before it got to 70, it crashed due to heater not heating at expected rate.
SSR lights up red, when heater is at 100% I'm showing a 0.4v drop across the switched side of the SSR, and across the leads of the bed I'm getting infinite resistance. Ideas? If it's a thermal fuse, why would that have happened, and is that even replaceable? For context, it's 110v and the printer has a few hundred hours on it.
18 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 9/27/2023 in #fix-my-print
Surface Artifacts
19 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 5/29/2023 in #fix-my-print
petg issues
7 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 5/4/2023 in #fix-my-mesh
Mesh After Enclosure
1 replies
RRCRat Rig Community [Unofficial]
•Created by Dante Tango on 12/24/2022 in #fix-my-printer
SuperPinda going bad?
Recently, I've had very inconsistent first layers and during probe moves, I've seen a lot of "probe samples exceed tolerance" with sometimes it failing to print because of this.
Any troubleshooting tips for this?
8 replies