Rat Rig Community [Unofficial]•2y ago

Toolhead Beta-400

Just did the FMMM, motor dampener, funnsor XY joiners, and switched to the toolhead beta 2. How do these graphs look?

MFBS•5/26/24, 11:04 AM

X is OK. Y has an issue.

Dante TangoOP•5/27/24, 6:30 PM

Any suggestions on where to start looking there?

Dante TangoOP•5/27/24, 6:31 PM

Also....why didn't it recommended MZV for X, if that resulted in 0 vibrations?

DDante Tango Also....why didn't it recommended MZV for X, if that resulted in 0 vibrations?

Ferfi•6/3/24, 7:51 AM

It's kinda random if it chooses ZV or MZV if the graph is fine.

DDante Tango Any suggestions on where to start looking there?

Ferfi•6/3/24, 7:52 AM

What frequency are the belts tightened to?
Run bed mesh to see if it is fine or if one corner is out which would point to frame.
My guess is that you will have to strip the belts and check Y alignment....

Ferfi•6/3/24, 7:55 AM

Perpendicularity can be different between printed and alu XY joiners so even if Y was fine before, it can be eh now.