SuperPinda going bad?
Recently, I've had very inconsistent first layers and during probe moves, I've seen a lot of "probe samples exceed tolerance" with sometimes it failing to print because of this.
Any troubleshooting tips for this?
7 Replies
The mount going bad is more likely, or one of the z couplers is loose
conscious-sapphire•3y ago
https://www.klipper3d.org/Probe_Calibrate.html#repeatability-check You could run this to see if it's giving consistent results
The mount feels tight to the print head, and I actually glued it to the mount to ensure it didn't rattle or loosen up
The Z screws, I can try that. But in that case, wouldn't Z tilt always get further out of range?
It moves up and down in the process
So I tightened the lead screws, seemed to print decently and then I just came back to it balled up.
Not exactly sure how much is broken, but that doesn't look good
So the screws definitely backed out... Is that also likely a broken heatbreak?
