Kosmák
RRCRat Rig Community [Unofficial]
•Created by Kosmák on 11/1/2024 in #fix-my-print
Weird ripple effect on otherwise flawless PETG-CF print
I dont understand that tho, because the outer walls are significantly slower than infill and that prints without any issues 👀
7 replies
RRCRat Rig Community [Unofficial]
•Created by Kosmák on 9/11/2024 in #ratos-support
RatOS homing behavior
I havent done the X/Y offsets yet, as I wanted to home the actual printer first and got a little sideswept by the homing failure
6 replies
RRCRat Rig Community [Unofficial]
•Created by Kosmák on 9/11/2024 in #ratos-support
RatOS homing behavior
thanks for the suggestions! Turns out sensorless homing was off a little, so sometimes it homed correctly other times not as much, so it was acting wonky.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Lemcott on 1/20/2024 in #fix-my-resonance
400 first graphs
This is like the best graph I have seen in a while
17 replies
RRCRat Rig Community [Unofficial]
•Created by xenial-black on 1/24/2023 in #fix-my-print
petg not printing with pla speeds
Im gonna come down at it from a different point of view. Are you sure your idler tensioner is properly tensioned?
I spent hours diagnosing possible clog, while in the end the ASA I was using just needed different idler tension on my orbiter 1.5
8 replies
RRCRat Rig Community [Unofficial]
•Created by absent-sapphire on 1/23/2023 in #fix-my-print
PETG layers not sticking on layers with high infill
You might be onto something with the bridging. What is your fan speed?
2 replies
RRCRat Rig Community [Unofficial]
•Created by Night on 1/14/2023 in #fix-my-mesh
X-axis problem in chamber
Doesnt have to be the bed only. Bimetallic expansion is a thing
19 replies
RRCRat Rig Community [Unofficial]
•Created by stormy-gold on 1/20/2023 in #fix-my-printer
VC-3.1 500 - belt jumping out of flange
You might need to reallign pulley on the motor
20 replies