petg not printing with pla speeds
Hi,im having trouble printing pet g at my normal pla speeds,the temps are 250 nozzle and 70 bed,the fillament is polylite petg,this is how the print looks
5 Replies
statutory-emeraldOP•2y ago
should i try higher nozzle temp?
as it seems like its under extruding
also to clarify,i print normaly with pla at this speeds and at almost this speeds with abs to,so i know my hotend can flow at the needed flow rate
vicious-gold•2y ago
PETG generally needs printing a bit slower, with little to no cooling. Also PolyLite PETG is recommended 230-240 so possibly you are printing too hot.
Im gonna come down at it from a different point of view. Are you sure your idler tensioner is properly tensioned?
I spent hours diagnosing possible clog, while in the end the ASA I was using just needed different idler tension on my orbiter 1.5
PETG is a very different plastic compared with PLA or ABS. Don't expect it to print or behave in the same way. I've been printing quite a lot of PETG lately - almost certain your settings need adjustment... First - slow down, see what you get at 80mm/s speeds... Get good prints at slower speeds, then ramp up until quality starts to become unacceptable
statutory-emeraldOP•2y ago
Mhhhh,noted down everything,thanksss everyone