Rat Rig Community [Unofficial]•4mo ago

RatOS homing behavior

Hi guys, I recently swapped to RatOS, just wanted to ask what the homing behavior is supposed to look like, since when I homed last night, the probe was left hanging out of bed in the front left corner and the bed crashed like hell 😅

Solution:

thanks for the suggestions! Turns out sensorless homing was off a little, so sometimes it homed correctly other times not as much, so it was acting wonky.

Jump to solution

3 Replies

blacksmithforlife•4mo ago

you need to adjust your offsets so that 0,0 is on the front left of the bed corner. So home X, and then home Y (DON'T HOME Z). tell it to go to 0,0. Then adjust until it is on the left corner. Whatever the difference is, is what you need to adjust for your x and y offset

[stepper_y]
position_endstop: <your size - the offset>

[stepper_x]
position_max: <your size - the offset>

[stepper_y]
position_endstop: <your size - the offset>

[stepper_x]
position_max: <your size - the offset>

Solution

Kosmák•4mo ago

thanks for the suggestions! Turns out sensorless homing was off a little, so sometimes it homed correctly other times not as much, so it was acting wonky.

KosmákOP•4mo ago

I havent done the X/Y offsets yet, as I wanted to home the actual printer first and got a little sideswept by the homing failure

Gaming

Programming

RatOS homing behavior

Did you find this page helpful?